This usually means your PC was hard shutdown, sometimes operating system updates can cause this, Windows is most common, but not excluding OSX or Linux. You may need to refresh your peers, following this process will assist in gaining sync and acquiring a new peers list.
This is usually the second part of a two-part process called primer or restore
After primer finishes setup, wait 15 minutes and review stages below
Stage 1 or 2 - retry this process first
Stage 4, Is GOOD, the application is finishing sync- you do not need to continue this tutorial
Stage 5, Is FINISHED - you do not need to continue this tutorial
Stage 3, Proceed with Part 2, Step 1
-
- Open Settings
- Confirm or put check in advanced mode (after finishing step 6 you can remove it)
Before After (Or Confirm) - Now open Debug Console
- Unlock Divi Desktop (5 Minutes should be enough)
- Take not of the command entry area
- Use the following commands to add connection(peers) to achieve stage 4(syncing)
and stage 5(Fully Synced)
- Enter one at a time, cutting and pasting works best.
- However, if you receive a response with [ ], or error messages, don't fret you missed the syntax look at the examples offered below for examples.
Step 1) Paste these lines one at a time into the console bar as shown below.
addnode "178.128.246.77" onetry
addnode "192.241.200.155" onetry
Step 2) Click the Enter Button
A correct response will be null
Syntax (format) for examples
Correct responses will be null
- However, if you receive a response with [ ], or error messages, don't fret you missed the syntax look at the examples offered below for examples.
- Enter one at a time, cutting and pasting works best.
- Open Settings
After entry of the addnodes your application will begin to regain full sync.
*Troubleshooting
If upon entry of commands and IP you get a [ ] or error message, this means you need to try again and review the example above.
Syntax Errors , simply review and try again | |
![]() |
![]() |
Comments
0 comments
Article is closed for comments.